Monthly Archives: March 2015

R.K. Vest Pistol

by Woodsbum

Every once in a while I get roped into doing an off the wall task to help someone out. This time I ended up helping out a friend of mine with her grandfather’s old vest pistol. They did not know anything about this pistol and had found that it would jam up consistently. It appeared that the feed ramp on the barrel was hanging out too far and was catching the lip of the casing when a new round was fed from the magazine. Being the highly motivated and overly DIY type person that I am, I went ahead and volunteered to polish up the feed ramps to get rid of this lip a bit.

Here is the pistol.

R.K. Vest Pistol

R.K. Vest Pistol

There is not much information available about this pistol, such as how to disassemble it or even what company made it. I finally found something on The Vestpocket Pistol Collector site. It really doesn’t say much:

History:

Gunmaker unknown, but from Spain.
Typical Eibar-pattern, proofing code “star over D” indicates this pistol is from 1931.

Technical Data:

SYSTEM: self-cocking pistol with internal hammer
CARTRIDGES : 6
CALIBRE : .25 ACP
BARREL LENGTH : 57 mm , 6 grooves right hand twist
WEIGHT EMPTY : 390 g
TOTAL LENGTH : 116 mm
TOTAL HEIGHT : 83 mm
TOTAL WIDTH : 26 mm
TRIGGER : Single Action
SIGHT : fix groove
SAFETY : safety-lever
FINISH : blued
GRIPS : hard rubber

Here is what I see with the feed ramp.

Feed ramp

Feed ramp

The way that the barrel comes out is a bit bizarre. If you lock the slide to the rear, the barrel twists on lugs and then slides right out. I have yet to get the whole pistol apart to get a size for new springs. I did polish up the feed ramp for her, though. It would be nice to get the pistol apart to do some work on it with some fine sandpaper to smooth out the action a bit, but this should help it a lot.

Polished up a bit

Polished up a bit

Here is a bit of information such as schematics and such about the pistol. I still can’t get it disassembled, though. I am working on it and have faith.

Basic disassembly

Basic disassembly

Full schematic:
Full schematic

Full schematic

This is really a neat little pistol. I have hopes in getting it apart to smooth everything out as well as find a new spring to tighten up the action a bit. If you know anything about these or have any resources for these pistols, please comment and let me know.

  • Share on Tumblr

Gunfight Veteran Bob Stasch

Bob Stasch – Interview with a Chicago Police Department Veteran of 14 gunfights

  • Share on Tumblr